![]() Les résultats de la méthode proposée ont été comparés à ceux obtenus par quelques-unes des méthodes existantes d’analyse d’essais par paliers et se sont révélés plus fiables et solides. La technique a été testée avec des données synthétiques et avec des données de terrain on remarque que l’approche proposée fournit des estimations précises des paramètres de l’aquifère et des pertes de charge du puits. libres) et des aquifères non idéaux (i.e. La méthode proposée est applicable pour analyser des données obtenues non seulement sur des aquifères captifs idéaux, mais aussi sur d’autres types d’aquifères (i.e. Les paramètres de perte de charge sont alors obtenus avec une meilleure précision une fois identifié le comportement de l’aquifère. La fonction dérivée est ensuite intégrée pour obtenir le rabattement sous la forme d’une fonction continue du temps. La méthode proposée est basée sur la dérivée du rabattement en fonction du temps pendant toute la durée du pompage d’essai pour éliminer les termes de perte de charge indépendants du temps. Une nouvelle technique d’analyse est proposée pour interpréter les données d’essais de descente par palier en régime transitoire. The results of the proposed method were compared with those of some of the existing methods for analyzing step-drawdown test data and were found to be more reliable and robust. The technique was tested for synthetically generated and field data the proposed approach was noted to provide accurate aquifer and well-loss parameter estimates. The proposed method is applicable for analyzing data obtained not only from ideal confined aquifers but also from other aquifer types (i.e. The well-loss parameters are then obtained with higher accuracy once the aquifer behavior is identified. The derivative function is subsequently integrated to obtain the time-dependent aquifer drawdown as a continuous function. The proposed method is based on taking the derivative of the drawdown with respect to time for the entire pumping test period to eliminate the time-independent well-loss terms. ![]() A bailer test is not an acceptable substitute for testing wells under permit or for public water supply wells.A new analysis technique has been proposed for interpreting transient step-drawdown test data. Periods of observation shall be more frequent during the onset of the draw down and may decrease in frequency as the draw down or recovery proceeds. Periodic water level observation should be made during draw down and subsequent recovery periods. The yield and draw down shall be determined following at least four hours of constant rate pumping. The test pump for public water supply wells shall be operated continuously for a minimum of four hours, or longer if required by the department of health. The well shall be test pumped at rates equal to, or greater than, are expected from the well during its normal usage. ![]() The driller shall be familiar with and meet all testing procedures outlined in the water right permit. Reports of the test pumping shall be submitted as required in chapter 90.44 RCW. ![]() (1) Well authorized by appropriation permit - Before being put to use, each well shall be test pumped for yield and draw down. ![]()
0 Comments
Leave a Reply. |